Revolabs Car Speaker HDX 7000 User Guide

Revolabs Single Channel System - Polycom HDX 7000 Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a

Revolabs Single Channel System to a Polycom HDX 7000 video codec.

1. Connecting the Cables

2. Configuring the HDX 7000 Video Codec

Note: It is important to carefully follow these instructions in order and completely.

Otherwise your Single Channel System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)

3. Polycom HDX 7000 video codec

Configuring the HDX 7000 Video Codec

CONFIGURING THE AUDIO MENUS OF THE HDX 7000 VIDEO CODEC

1. Select SYSTEM

2. Select ADMIN SETTINGS and enter the Administrator password (if needed)

3. Select AUDIO

4. Select AUDIO SETTINGS

5. Disable POLYCOM MICROPHONES by removing the check mark. Having

Revolabs and Polycom microphones will increase ambient noise, add to echo

cancellation problems, and reduce articulation*

6. Verify LIVE MUSIC MODE is disabled by removing the check mark. Polycom

noise suppression is turned off when this is active

7. Select INPUTS/OUTPUTS

8. Confirm or modify the following settings:

a. INPUT TYPE is LINE INPUT

b. INPUT TYPE LEVEL is 80% or 8

c. ECHO CANCELLER is ON

9. Press OK to save all changes

NOTE: IF THE GOAL IS TO USE THE REVOLABS WEARABLE MICROPHONE OR XLR

PLUG-IN ADAPTER WITH THE HDX SYSTEM, THEN DISABLING OF THE POLYCOM

MICROPHONES IS NOT NECESSARY DUE TO THE MINUTE AMOUNT OF ECHO

CANCELLATION PROCESSING POWER NEEDED FOR THESE MICROPHONES. REVOLABS

DOES NOT RECOMMEND ADDING A REVOLABS BOUNDARY MICROPHONE TO AN

EXISTING HDX MICROPHONE SYSTEM BECAUSE OF ECHO CANCELLATION REFERENCES

AND VOLUME LEVEL DIFFERENCES.