R
RUB
TECH
Gigabit Switch
Networking & Communications
L2 Managed PoE Switch
PSES-2126C
PSES-2126C: 26-Port L2 Managed Fast Ethernet PoE Switch With 2 SFP Dual Media
Key Features
Standard compliance
Benefits
PoE Save Your Power Infrastructure and Installation Cost
24-PoE ports allow power (185W) to be supplied to end devices, such as
Wireless Access Points or VoIPPhones, directly through the existing LAN
cables, eliminating costs for additional AC wiring and reducing Installation
Cost. It frees your wireless AP deployment from restriction due to power
outlet location. By supplying the power end-span, you can centralize power
distribution and backup without the need to increase infrastructure.
QoS with Four Priority Queues
---IEEE 802.3 10Base-T Ethernet
(twisted-pair copper)
---IEEE 802.3u 100Base-TX Ethernet
(twisted-pair copper)
---IEEE 802.3ab 1000Base-T Ethernet
(twisted-pair copper)
---IEEE 802.3z 1000Base-SX/LX
Ethernet
The QoS(Quality Of Service) feature provides four internal queues to support
four different classifications of traffic. High priority packet streams experience
less delay inside the switch, which supports lower latency for certain delay-
sensitive traffic. The PSES-2126C can classify the packet as one of the four
priorities according to vip port, 802.1p priority tag, DiffServ and/or IP TOS.
The QoS operate at full wire speed. The actual scheduling at each egress
port can be based upon a strict priority, weighted round robin or a mix of both.
Port Mirroring
---IEEE 802.3x flow control capability
---ANSI/IEEE 802.3 auto-negotiation
---IEEE 802.1q VLAN
RoHS Compliance
Subscriber Interface
---Port 1-24 are 10/100Mbps Fast
Ethernet ports.
---Port 25,26 are Gigabit TP/SFP Fiber
auto sense
This mechanism helps track network errors or abnormal packet transmission
without interrupting the flow of data. Allow ingress traffic to be monitored by a
single port that is defined as mirror capture port. The mirror capture port can
be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but
can create congestion at the mirror capture port.
---Auto-Negotiation and Auto-MDIX
---Backpressure flow control for half
duplex.
---802.3x flow control for full duplex.
---Connector: 24 RJ-45 and 2 dual
media, RJ-45/SFP
Q-in-Q VLAN for performance & security
The VLAN feature in the switch offers the benefits of both security and
performance. VLAN is used to isolate traffic between different users and thus
provides better security. Limiting the broadcast traffic to within the same
VLAN broadcast domain also enhances performance. VLAN support enabling
advanced techniques such as "802.1Q-in-1Q" to be deployed.
Isolated Group, Provide Secure for Certain Ports
Performance
Switching capacity:
---Non-blocking switch fabric supports up
to 24FE+2GbE, ports
---8 K MAC addresses
---256k packet buffer and 128k control
memory
The isolated group feature allows certain ports to be designated as protected.
All other ports are non-isolated. Traffic between isolated group members is
blocked. Traffic can only be sent from isolated group to non-isolated group.
Mac-based 802.ad LACP with Automatic Link Fail-over
---The maximum throughput is 8.8Gbps
---With 64 bytes packets throughput is
6.547Mpps
Dynamic fail-over means packets will not get assigned to any trunk member
port that has failed. If one of the ports were to fail, traffic will automatically get
distributed to the remaining active ports.
VSM(Virtual Stacking Management)
---Support 16 devices stacking
---Multiple switches can be managed via
one IP address, just like software
stacking
802.1x Access Control Improve Network Security
802.1x features enable user authentication for each network access attempt.
Port security features allow you to limit the number of MAC addresses per port
in order to control the number of stations for each port. Static MAC addresses
can be defined for each port to ensure only registered machines are allowed
to access. By enabling both of these features, you can establish an access
mechanism based on user and machine identities, as well as control the
number of access stations.
---Low cost and easily to establish
network environment, not extra
hardware require.
---Not center on the physical location of
wiring closets
VLAN
802.1d Compatible & 802.1w Rapid Spanning Tree
---Supports SVL/IVL configuration to
meet your VLAN requirement
---Port-base VLAN
For mission critical environments with multiple switches supporting STP, you
can configure the switches with a redundant backup bridge path, so
R
RUB
TECH
Gigabit Switch
Networking & Communications
L2 Managed PoE Switch
Technical Specifications
Hardware Spec.
---Supports per port power priority
setting
Protocol
Feature
Detailed Description
LACP
---2 Fast Ethernet +1 Gigabit Ethernet
groups
Voltage
100~240 VAC
Frequency
50~60 Hz for AC Power
---Per-group max 4 members
---Provides DA, SA and DA+SA Mac-
based trunking with automatic link
fail-over
GVRP/GARP
---802.1q with GVRP/ GARP
Multicasting
---Supports IGMP snooping including
active and passive mode
STP/RSTP
Power Requirement
Total Power for PoE
Ambient Temperature
Humidity
210W
185W
0 to 40 C
5% to 90%
Dimensions
Weight
45(H) x 442 (L) x 366 (W) mm, 19" 1U
3.3kg
Safety
Comply with FCC Part 15 Class A &
CE Mark Approval
---802.1d/1w/1s STP
Network Security
---802.1x access control
---Isolated group
Packing Information
Carton Dimensions (mm)
530x512x345
pcs/Carton
N.W (KG)
G.W (KG)
5
21
22
---Restricted group
---Management Access Policy Control
---Static mac, to limit which mac
addresses can pass through or not
---Mac addresses learning limit, to set up
the maximum amount of mac that
each port can learn
PSES-2126C
26-Port L2 Managed Fast Ethernet PoE Switch
With 2 SFPDual Media
Snmpv1,v2c Network Management
RFC 1213 MIB (MIB-II)
---Interface MIB
---Address Translation MIB
---IP MIB
---ICMP MIB
---TCP MIB
---UDP MIB
---SNMP MIB
Optional SFP Module
SFP.LC
1000Base-SX GE SFPFiber Module,
LC Multi-Mode 850nm
SFP.LC.M2
1000Base-SX GE SFPFiber Module,
LC Multi-Mode 1310nm 2km
Note:
We recommend the SFP transceiver from thefollowing vendors:
1. Ruby TechCorporation
RFC 1757 RMON MIB
---Statistics Group 1
---History Group 2
2. Agilient Technologies
3. AVAGOTechnologies
---Alarm Group 3
4. Finisar Corporation
---Event Group 9
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
Enterprise MIB
Overview
PSES-2126C supports 24 10/100Mbps
Auto-negotiation, Auto-MDIX Ethernet
ports and Power over Ethernet to IEEE
802.3af compliant devices. With the
24-port featuring PoE function, the
PSES-2126C is an ideal solution for
wireless AP, VoIP phones, security video
cameras. It's fully compliant with the
standards of IEEE 802.3/u/x/z/ab/af. It is
equipped with 24 UTP (RJ-45) ports and
2 of which are dual media ports that
accommodate optional 10/100/1000
Base-T or SFP modules. In addition, the
switch implements the QoS (Quality of
Service), Mac Filtering Policy, Port Mirror,
VLAN and full L2 protocol. The overall
network management is enhanced and
the network efficiency is also improved
to accommodate high bandwidth
applications with security.
Ruby Tech Corp.
3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan
TEL:886-2-2785-3961 FAX:886-2-2786-3012
http://www.rubytech.com.tw
E-mail [email protected]
Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.
Copyright
c
2008 Ruby Tech Corp. All rights reserved.
2008-07.25 Version A
|